Vert-A-Sheer Sheer Verticals Installation Instructions
Please follow these simple instructions to install your new Vert-A-Sheer®For Outside Mount
For Inside Mount
|
|
|
Note: Sheer material must be handled with extreme care to avoid any snags or pulls. |
|
Step OneStarting with second vertical slat, remove slat from track and insert slat into second receiving socket of Vert-A-Sheer and re-attach to track. Note: Top of Vert-A-Sheer has a gap to allow stem of carrier to slide through and attach to vane. |
Step TwoContinue this procedure until all but first and last pocket of Vert-A-Sheer are attached to track. For a split draw, there will be a total of four vanes left unattached, one on each end and two in the middle. |
Step ThreeFor remaining slats, receiving pockets of Vert-A-Sheer are slightly different. Insert slat into pocket and attach to track. If stem of carrier does not attach to slat, then slat is not inserted into pocket correctly. |
Step FourAfter all tops of slats are inserted, then place the bottom of slats into the spaces provided at the bottom. |